offbeat
no posts
Member since May 2010
Posts: 0
|
Post by offbeat on Sept 23, 2006 23:07:03 GMT -5
Thought I would cross post this here. I have an old B&I Gem maker that hasn't been put into service in my shop at this time. I did bump into a guy on ebay that was selling a new unit that included instructions. Short story, I got a copy of the manual sent to me.
These instructions might help out with other types of grinders simular to the G&I. This is the type of grinder that has one wheel with a verticle shaft. Water drip can. Multi pulleys on the bottom.
I know a few here on the board have one of these. Let me know and I can forward this instruction manual to any who need it. It is in jpg form (6 of them). Take care, Bill
|
|
offbeat
no posts
Member since May 2010
Posts: 0
|
Post by offbeat on Sept 23, 2006 23:09:13 GMT -5
Forgot to mention, no charge of course! Bill
|
|
cmp
off to a rocking start
Member since January 2020
Posts: 4
|
Post by cmp on Jan 9, 2020 10:29:38 GMT -5
I was wondering if you are still on this board and if you still have the instruction manual for the B&I gem maker? I just acquired an old one and have no idea how to use it. I sure would appreciate any help I can get. Thanks. Cris
|
|
|
Post by aDave on Jan 9, 2020 13:26:01 GMT -5
I was wondering if you are still on this board and if you still have the instruction manual for the B&I gem maker? I just acquired an old one and have no idea how to use it. I sure would appreciate any help I can get. Thanks. Cris Just a heads up, but that member hasn't been on since 2012. You might need to create your own thread and ask if anyone can help. Good luck.
|
|
cmp
off to a rocking start
Member since January 2020
Posts: 4
|
Post by cmp on Jan 9, 2020 22:31:19 GMT -5
Thanks for the info. I knew it was a long shot but thought I'd try.
|
|
|
Post by hummingbirdstones on Jan 9, 2020 22:36:03 GMT -5
cmp Here's a link to one from the Dallas Gem & Mineral Society:
|
|
hank
off to a rocking start
Member since October 2018
Posts: 3
|
Post by hank on May 20, 2022 10:39:18 GMT -5
|
|
shelleyruss
off to a rocking start
Just here for some rock talk
Member since September 2023
Posts: 1
|
Post by shelleyruss on Sept 25, 2023 15:26:54 GMT -5
Any chance any of you saved the gem maker manual, or has a copy, and could upload it to the forum? (fingers crossed) The links aren't functional anymore sadly.
|
|
|
Post by liveoak on Sept 26, 2023 8:37:56 GMT -5
shelleyruss, I have a pdf copy, but don't know how to upload a pdf to the forum. If you want to pm me your e-mail I can send it. Patty
|
|
|
Post by liveoak on Sept 27, 2023 17:38:13 GMT -5
Any chance any of you saved the gem maker manual, or has a copy, and could upload it to the forum? (fingers crossed) The links aren't functional anymore sadly.
OK, here you go - I got Tommy to upload it.
Hope it helps- I have one of those flat laps - they are a good machine.
Patty
|
|