|
Post by stardiamond on May 16, 2019 17:59:43 GMT -5
When I finish? a cab I put it in a Riker box. I was searching through cabs and saw some cuts/imperfections not scratches where marked. I noticed a big dip in the bottom of the girdle on the same side. I then noticed the nose was misshapen. Additionally the girdle was pretty fat. I'll take it off the dop, cut a diagonal from the nose to the bottom, redome and redo the girdle. I'm posting the before now. Sorry for the fuzzy picture. I could have ground around the girdle and redomed, but when flaws show up in the material there is no guarantee they will go away with additional grinding.
|
|
|
Post by stardiamond on May 18, 2019 18:33:13 GMT -5
Changed it to a freeform. A lot of grinding and through 325. Dark rainy day so picture doesn't show a lot.
|
|
followthatcab
noticing nice landscape pebbles
Member since May 2019
Posts: 76
|
Post by followthatcab on May 19, 2019 5:29:32 GMT -5
Very nice save!
|
|
|
Post by stardiamond on May 19, 2019 13:31:50 GMT -5
I did a good job on it but some cabs are cursed. On the left side of the arc in the lower area there is a 1.5 mm pits/vug. I'm done with it.
|
|