|
Post by Rockoonz on Jan 30, 2010 13:20:20 GMT -5
wow thats cool i just started slabbin again and i think i need a tune up on my saw its cutting very slow and i tried 3 dif blades so its not that -- i have to empty and flip over and check the spring that makes it grab the treaded bar cause its seems to be skipping to much -- like two or three hrs a slab Before you change the spring tension on your half-nut check your blade alignment and the bearings on your vice carriage. The spring load on your half nut is there to keep your saw from self-destructing in the middle of a cut. Lee
|
|
|
Post by Donnie's Rocky Treasures on Jan 30, 2010 18:41:02 GMT -5
Mel, that is beautiful, I am jealous. Do ya have any hint where I can find some of that kind of gravel around here?! HaHa!
|
|