zrock1
off to a rocking start
Member since January 2016
Posts: 24
|
Post by zrock1 on Feb 15, 2016 19:41:41 GMT -5
I see them returning phone calls is going to be as quick as their reply to my email!
|
|
zrock1
off to a rocking start
Member since January 2016
Posts: 24
|
Post by zrock1 on Feb 14, 2016 19:25:19 GMT -5
Thanks for all the replies... I'm going to be calling them in the morning but I'm not holding my breath since I emailed them 3 weeks ago on another issue with 0 response. .. unfortunately all the good deals on barrels are in the USA and I'm in canada so I'm looking at $40+ to get a barrel. I'll just order a lortone instead...
|
|
zrock1
off to a rocking start
Member since January 2016
Posts: 24
|
Post by zrock1 on Feb 14, 2016 1:44:46 GMT -5
I bought my little one a mp-1 tumbler for xmas. We have had it running for about 8 weeks now just finishing up the second batch. I just noticed today during cleaning getting ready for polish that on the bottom of the barrel is starting to crack. Right in the middle where it looks like the injection point for the molding process. The barrel seems to get a slight vacume in it so this point is seeing a lot of flex? Think a rubber patch for tire repair would seal this up if put on the outside? Don't want to buy a new barrel already at about $40+ at my local hobby shop. I'll just by a diffrent tumbler if this is not going to last more than 2 months at a time.
|
|
zrock1
off to a rocking start
Member since January 2016
Posts: 24
|
Post by zrock1 on Jan 27, 2016 20:39:43 GMT -5
Guess it depends on where u shop. I found my last order of supplies quite reasonable. But of course I was comparing to local where it would have cost 10x the amount
|
|