RWA3006
Cave Dweller
Member since March 2009
Posts: 4,240
|
Post by RWA3006 on May 14, 2018 19:27:38 GMT -5
I'm considering making a horizontal rotary flat lap from a second hand electric pottery wheel. Anyone done this before? Observations?
|
|
|
Post by woodman on May 14, 2018 20:04:34 GMT -5
I'm considering making a horizontal rotary flat lap from a second hand electric pottery wheel. Anyone done this before? Observations? This should take you to the one I purchased last year. I would be concerned about the speed of the lapping plate, you don't want it to go too fast. forum.rocktumblinghobby.com/thread/78673/36-inch-flap-lap
|
|
RWA3006
Cave Dweller
Member since March 2009
Posts: 4,240
|
Post by RWA3006 on May 14, 2018 20:45:57 GMT -5
I'm considering making a horizontal rotary flat lap from a second hand electric pottery wheel. Anyone done this before? Observations? This should take you to the one I purchased last year. I would be concerned about the speed of the lapping plate, you don't want it to go too fast. forum.rocktumblinghobby.com/thread/78673/36-inch-flap-lap Thanks. Learned a lot from that thread.
|
|