vwfence
has rocks in the head
Member since January 2013
Posts: 557
|
Post by vwfence on Feb 4, 2022 14:51:51 GMT -5
Does anyone have a LS12 table and crossfeed that they would part with off of a nonworking saw ? I need something to make parts patterns to build one
|
|
|
Post by oregon on Feb 4, 2022 16:05:36 GMT -5
I have one of these sitting on the bench, IMHO, I'd start over instead of copying. sheet metal is near worn through that rides on the rails on this one, and I never liked how tightening the bearings relied on flexing the metal tabs that hold them. Split nut hole is egged out(again thin metal) which causes binding/alignment issues.. Rails have some flats worn on them too on this saw...
They were fine saws, probably built/designed with cost effectiveness in mind for the not so serious, casual home use. Fit those criteria well for the time.
2c.
|
|