|
Post by liveoak on Apr 4, 2023 9:43:16 GMT -5
Finally fixed the drainage issue ! For those that don't know, or don't have one, the KN cabber has drain tubes that exit the back of the cabber. Since the drain tube exits the cabinet behind the wheels, but in front of the motor, there is a 5-6" long flat section of hose, laying flat on the table, that prevents the hoses from draining well. At first I thought it was funny to share this modification, as I thought OK people must just have narrower benches - But I realized, with the motor behind, that's not possible. I've tried propping up the cabber, to the point of instability, to get it to drain - NOT good! But yesterday Tom fixed it once & for all - he drilled holes (big holes) through my stainless steel table. Now the hoses immediately exit the cabinet on a downward angle & "Bob's-yer-Uncle"- It works terrific. Of course this could also be done on a wood table, and according to Tom, it would be a lot easier than making big holes in stainless steel ! Funny, how a couple of holes can be a game changer & make life just a little nicer.
Patty
Back Of Cabber:
Underneath the table :
|
|
|
Post by Rockoonz on Apr 4, 2023 10:59:02 GMT -5
Sometimes gravity is your friend.
|
|
stefan
Cave Dweller
Member since January 2005
Posts: 14,113
|
Post by stefan on Apr 9, 2023 15:52:35 GMT -5
Have the same issue with my CabKing. My table is pressboard and this is on my list of todo's. I already T'ed the lines together so I only have one hose running into the waste bucket, but I gotta get a better run as mine sit too flat as well. Love how you have the mat on there so you really can't even see the holes!
|
|
|
Post by liveoak on Apr 9, 2023 18:52:55 GMT -5
Thanks stefan It's just a cheap yoga mat, and it keeps the unit in place pretty good.
The holes were well worth the effort !
Patty
|
|