rcadamssr
off to a rocking start
Member since January 2009
Posts: 5
|
Post by rcadamssr on May 25, 2010 11:15:11 GMT -5
I have a 10" saw-what is the max cutting height and depth that should be attempted? Thanks in advance for your input
|
|
|
Post by jakesrocks on May 25, 2010 11:40:22 GMT -5
It depends somewhat on the diameter of the large washer holding your blade, but a 4" X 4" rock should be safe. Does your saw have a power or weight feed ? If so, watch that the rock doesn't jam against the washer holding the blade. Happy cutting. Don
|
|
Sabre52
Cave Dweller
Me and my gal, Rosie
Member since August 2005
Posts: 20,487
|
Post by Sabre52 on May 25, 2010 13:24:51 GMT -5
Yeah, with my 10" saw the maximum depth is controlled by space in front of the blade which is about 4 1/2 inches. Theoretically, I can go about 4" high on the workpiece but I usually try to keep it to three inches or so . The blade when old tends to bog down on those 4" thick cuts if the material is hard.....Mel
|
|
|
Post by johnjsgems on May 26, 2010 8:43:52 GMT -5
Most manufactured 10" saws will cut 3.5" tall but length is up to saw design and vise. If it fits in the vise it will be safe to cut.
|
|
|
Post by deb193redux on Jun 2, 2010 20:41:46 GMT -5
I find that thicker/stiffer blades fare better with 3+ inch cuts. thinner blade (.032 or less) any you should stay under 3"
|
|
|
Post by rocklicker on Jul 4, 2010 17:06:27 GMT -5
I tend to stay around 3 to 3.5 inches even with a thick blade. If your saw does not have an autofeed, make sure you go nice and slow to avoid heat buildup. I found the larger rocks tend to heat up in a 10 inch saw. Steve
|
|