|
Post by miket on May 31, 2019 9:40:12 GMT -5
So I had this slab that I cut in the rotary for quite a while. It had a crack across the middle but I just kind of wanted to see what happened. I checked barrels last night and sure enough it had broken. What else was I supposed to do- I couldn't throw it in the trash. I cabbed it, I like the colors. Unfortunately the second cab has a crack across the entire surface and I'm sure the tip is going to fall off. Anyway, here's the slab and what I did with it. Thanks for looking.
|
|
|
Post by rockjunquie on May 31, 2019 12:41:41 GMT -5
Been there, done that. Sometimes... ya just can't toss it. Good save!
|
|
|
Post by Pat on May 31, 2019 12:56:00 GMT -5
Good save; I like the two new cabs.
|
|
|
Post by miket on May 31, 2019 14:44:31 GMT -5
Been there, done that. Sometimes... ya just can't toss it. Good save! Thanks. Not sure if I should just bite the bullet, snap off the tip of the teardrop shaped one and make a smaller teardrop shape. I can't remember exactly but as is I think it's an inch and a half to two inches long.
|
|
|
Post by miket on May 31, 2019 14:46:01 GMT -5
Good save; I like the two new cabs. Thank you. I liked the colors, kind of reminds me of a desert scene...
|
|
|
Post by fernwood on Jun 3, 2019 5:24:08 GMT -5
Nice save.
|
|