herb
spending too much on rocks
Member since November 2011
Posts: 476
|
Post by herb on Aug 23, 2020 15:21:35 GMT -5
Hi everyone, I have a dozen or so geodes that are supposed to be from Indiana. I've sliced a few in half and started to grind one on my vibratory flat lap in order to polish it. This is what I found towards the end of the 200 grit grinding stage: IndianaGeode by Shiny Objects, on Flickr Obviously a bummer to see one of the halves had fallen apart. Is there anything special that has to be considered when flat lapping these? They seem rather soft, so I was hoping they'd be easy to polish. I noticed that when cleaning the oil off from the saw, the water was very brown. Even when sitting wet for awhile, I noticed when I picked one up the water puddle underneath was quiet brown like the rock is dissolving from being in contact with water. Is this normal for these geodes, or do I just have some inferior geodes? Are there any tricks that can help me end up with polished halves instead of pieces? Thanks! Herb
|
|
kyoti
has rocks in the head
Member since June 2020
Posts: 542
|
Post by kyoti on Aug 23, 2020 17:52:50 GMT -5
My Arkansas geode was the same way. It was too fragile to polish and crumbled a bit when I tried. I wondered if there is a way to stabilize the fragile geodes.
|
|
herb
spending too much on rocks
Member since November 2011
Posts: 476
|
Post by herb on Aug 24, 2020 9:32:59 GMT -5
My Arkansas geode was the same way. It was too fragile to polish and crumbled a bit when I tried. I wondered if there is a way to stabilize the fragile geodes. I wondered also if there was a way to stabilize them. I dont know of anything that would work without leaving the surface looking artificial. Epoxy, for instance would leave the surface with an unnatural shine.
|
|