|
Post by Donnie's Rocky Treasures on Jan 27, 2014 12:29:43 GMT -5
Larry, this is the best I can do with the shot of the bearings. Taken from both sides, squatting down (I'm short anyway).
|
|
QuailRiver
fully equipped rock polisher
Member since May 2008
Posts: 1,640
|
Post by QuailRiver on Jan 27, 2014 15:57:34 GMT -5
Donnie, Those look to be mounted correctly. So as long as the set screws are tight that arbor should not be able to drift. I hope everything works great for you now. Those Lortone 10" saws are real work horses. I made the mistake of selling mine and replacing it with a new 12" Lortone a couple of summers ago and I would rather have my old 10" Lortone back. Larry C.
|
|
|
Post by Donnie's Rocky Treasures on Jan 27, 2014 16:43:03 GMT -5
I have heard that from more than one source! Now I need to align it & dangnabit I can't see into the back of the saw to see if my pencil marked it. Going to have to rig up a light or something, plus get my magnifying glasses. That's one thing I liked about the old HP 10" I was using (still will be too), everything was right out in the open & I could see! Thanks a bunch everyone for your help
|
|
Deleted
Deleted Member
Member since January 1970
Posts: 0
|
Post by Deleted on Jan 27, 2014 17:07:23 GMT -5
I am late to the paety. Good thing though cuz I am learning with nothing to add.
Donnie, for the long run i think you will be better for this thread. You know far more about your saw than most. In the future if something shifts you will be confident in a quick adjustment and back to work.
Great job everyone, thanks for the education.
|
|